 see demo here |
The Fixture Arms | The arms hold the tubular hoop perfectly square with the work surface and directly over the lower ring. All you have to do is align the shirt and press the hoop down. With the Fixture arms holding the hoop for you, it allows you to concentrate more on the shirt and the actual placement of the logo. This speeds the hooping process and makes it much more accurate. |
 |
Pocket Alignment Guides | The Pocket Alignment Guide is designed to provide a precise alignment grid for pockets and striped shirts. It can also align lettering to existing logos. The Pocket Alignment Guide never needs to be adjusted like a laser, and is 1/10 the cost. It is completely portable and makes hooping shirts with pockets and stripes simple. The Pocket Guide is versatile and can be used with the HoopMaster, or your existing hooping device. |
 see demo here |
Magnetic Backing Material Holder | Eliminates the need to use tape, clips, or messy spray adhesive. The magnetic flaps hold the backing material in place over the lower ring while you hoop the garment. Holding the backing taut while the garment is hooped helps keep registration on the logo. The backing holder also allows you to use the smallest possible piece of backing since it will hold it in place while you hoop. |
 |
Number and Letter Grid | The grid is used to document logo placement for repeat orders. For example, when you document that a logo is placed at "D19 all repeat orders will be consistent and easy to set up |
 see demo here |
Pins on the fixture | There is no hardware to adjust or lose when changing logo location or hoop size. The pins automatically square the fixture with the work surface. Simply lift up the fixture and set it down in a new location using the self-aligning pins. |
 see sample here |
Rim on the fixture | The raised rim on the fixture recesses the hoop ring at the correct depth every time. This holds the garment taut while being embroidered. If you do not recess the hoop ring, you can have more bird nesting problems and the hoop ring can more easily fall off while in the machine. |
 |
Jacket Back Frame | The JBF is used on the station and has magnetic flaps to hold large backing in place while you hoop. Makes hooping jackets and large garments much easier |
 |
Cap Back Fixture | The CBF is specifica1ly designed to hoop caps and other garments in very tight places. The front of this fixture is just big enough to support the lower ring. This small size makes it easy to pull the backs of caps onto the fixture for hooping |
 |
| Find out more about the Hoopmaster Station |
